Parker-hannifin PA Series Manual do Utilizador descarregar pdf (Página 19)

Chapter 2: Installing the PowerStation Installing the PA PowerStation

PA PowerStation User Guide 2-8

3 Slide the feet of the mounting clip into the larger portion of the slot,

then slide the clip over to properly mount the unit.

4 Tighten each of the mounting screws against the front of the

enclosure.

5 For 5” and 6” units: Torque them down to 6 in/lbs.

For 8” and 15” units: Torque them down to 7in/lbs.

For 10” units: Tighten so that the gasket seal maintains a 50%

compression of the gasket. You may see a small gap between the

bezel and the enclosure.

6 Tighten the screws in a crosswise sequence to ensure a good seal

and prevent damage. Tightening the bracket assembly may not

ensure that the gasket seal is totally depressed by the bezel. You

may see a small gap between the bezel and the enclosure.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 64 65

Sem comentários

Parker-hannifin PA Series Manual do Utilizador Página 19